Cura Glitch? or User Error? - UltiMaker Cura - UltiMaker Community

I had a glitch operating Cura with my UM3 so I did a fresh install. After the install I tried running a print with my other machine (Monoprice Maker Select v2). At first I thought I was having a hardware issue, but I have eliminated those causes. The print does not stick to the surface at all. It

5.3.0 strange artifacts in skin (jagged paths on curved surfaces

Model Errors Message - UltiMaker Cura - UltiMaker Community of 3D

Cura no Disk error - UltiMaker Cura - UltiMaker Community of 3D

Can You Install Cura on Raspberry Pi? (Step-by-step guide

Ultimaker cura slices fine but on reading the gcode again through

CURA ultimaker Community

5.5.0-b1] Initial layer speed not honored · Issue #17010

Is something wrong with Cura? : r/Cura

Ultimaker Cura 4.8: Enabled for the 2+ Connect

Nasty Cura 5 Bug

Add Sovol SV06-Plus to the Latest Cura Software

Ultimaker Cura 4.8: Enabled for the 2+ Connect