Pre-printing 3 dabs - 3D Fabrication - Dallas Makerspace Talk

I’m sure most of you have watched the polyprinters start a print. They begin by preheating the extruder and then go to the front left corner of the bed to deposit 3 little dots to prime the extruder. My question is: Is this part of the G-code pre-processor script, or is it a function of the KISSlicer software? I’d like to do something similar for my Ender 3 and using PrusaSlicer, but I’m lazy and don’t want to figure out how to do it myself. 🙂 @frank_lima @AndrewLeCody

3D Fabrication - Dallas Makerspace Talk

Current news on 3d printing • sketchUcation • 16

Using Open-Source, 3D Printable Optical Hardware To Enhance Student Learning in the Instrumental Analysis Laboratory

Morgan Hamel, Author at re:3D, Life-Sized Affordable 3D Printing

3D Printing a Culture Change on the Factory Floor

UPDATED April 2nd - From Design to Mass 3D printing of Medical Shields in Three Days - Original Prusa 3D Printers

DF YoungTalk - Experimental 3D Printing with Custom Materials - Now

UPDATED April 2nd - From Design to Mass 3D printing of Medical Shields in Three Days - Original Prusa 3D Printers

3D Fabrication - Dallas Makerspace Talk

Mini-Satellite Projects Take Flight in Orbit

Dallas Makerspace Talk

The State of 3D Printing and Scanning After CES 2014: The Push For Mainstreaming Begins - Make

Current news on 3d printing • sketchUcation • 16