First layers K8400 - Software (Repetier & Cura) - Whadda forum

Forum. I have a problem printing the first two layers. With a hole within the model, the outline is only printed twice, while the edges are printed 3x for the outline of the entire model. With the next layers, all edges are printed 3x. Another question, the setting so that the nozzle does not go over the finished model so that no wires are pulled over the model. Greetings Auke

Scratching surface when travelling - Software (Repetier & Cura

First Layer Quality - Official Raise3D Community

PART 1: Beginner Cura 4.8 Tutorial (Software Install, Overview

Problems printing black PLA filament - Vertex - Issues while

Supports first layer is not right - UltiMaker Cura - UltiMaker

Cascade - studio kestra

3.04 Auto Layout raising model by first layer height · Issue #2792

First layer curling at edges causing print to fail – General

First layer calibration under extrusion issue · Issue #1967

First Layer issues (still) - Repetier-Forum

Repetier host, Dual head - Vertex - Printer software (repetier