Extra Retraction at Start - UltiMaker Cura - UltiMaker Community

Can someone explain why I am getting an extra retraction command right before my skirt starts? When I print, the filament doesn't print for sometime because of the extra retraction. I have tried it in both 3.4.1 and 3.5. Maybe I have a setting that is checked or set wrong. Below is my gcode from

Scalable extra prime - UltiMaker Cura - UltiMaker Community of 3D

5 Best Plug-ins for Cura

Extra gcode in the files from Cura. - UltiMaker Cura - UltiMaker

4.7.0] Retraction Extra Prime Amount - Only on First Layer · Issue

Bency test print on Ender 3X (Direct Drive) using PLA & Ultimaker

Stringing Nightmares: How Cura's Travel Settings Can Save 3D

Cura 2.7 strange retract behavior - UltiMaker Cura - UltiMaker

ultimaker cura - Stuttering extrusion after layer change - 3D

analyze retractions and Z hop - UltiMaker Cura - UltiMaker

slicing - Ultimaker Cura is not always retracting in exported G

Extra Retraction at Start - UltiMaker Cura - UltiMaker Community

Ultimaker Cura 5.0.0 : r/Cura