Z offset issues – PrusaSlicer – Prusa3D Forum

Hi, I switched from cura to prusaslicer and ran into strange issues with z offset. I have matched the machine config, pre-code, and post-code in bot

Switched to .8mm Nozzle and found out the first layer calibration

Stringing with prusaslicer solved with Cura – How do I print this

Feature Request: Move Z-Offset to Filament Section · Issue #602

Issues with printing file – How do I print this? (Printing help

Probe X & Y Offset – PrusaSlicer – Prusa3D Forum

Prusa Slicer 2.6 - Organic Supports, Embossing and More!

First layer under bed when negative z offset is set – PrusaSlicer

Too high? I set the Z offset and levelled the bed with a feeler

First benchy z offset too low? – Assembly and first prints

Printer keeps forgetting Z offset – Hardware, firmware and

Perfect first layer issues – Assembly and first prints

Prusa Slicer not generating supports : r/prusa3d