Tuning overhangs - Bambu Studio - Bambu Lab Community Forum

I’m trying to understand how to tune overhangs for my Polymaker ASA filament. I had dialed the fan speed way down to promote layer adhesion, except for overhangs. But overhangs came out shitty: I had: 0% fan @ 35s 20% fan @ 5s 100% fan for overhangs I then adopted the bambu ASA fan settings (leaving everything else the same): 25% @ 35s 90% @ 3s 80% for overhangs The result is much better: Notice that the bad model has 100% fan for overhangs and the good one only 80%. So is less fan

Print Quality Issue, Overhangs, X1 Carbon, PLA - Bambu Studio - Bambu Lab Community Forum

Bambu Studio: How & WHY to use Support Overhang Shading. Also Orca! Bambu Lab P1P - P1S - X1C

Slow Down for Overhangs

I wanted to try out the new ASA made by Bambu as I have always used non- Bambu filament with Generic Profiles. I understand with Generic Profiles you need to do some tweaking

The 3 Best 3D Printers for 2023

How to do support structures for small round overhangs in Bambu Studio : r/BambuLab

Tuning overhangs - Bambu Studio - Bambu Lab Community Forum

Bambu Lab P1S Desktop Organizer by 3DPrintsAndBeyond - MakerWorld

How do I get everything to print at the same speed? - Troubleshooting - Bambu Lab Community Forum