What would cause this? - Bambu Lab X1-Carbon - Bambu Lab Community Forum

The original hot end ended up getting bent (don’t know how, but it did). I replaced it with the included replacement. I did a calibration and everything looked fine. I went to print a simple model on extra fine 0.08mm on the BBL textured PEI plate (as see in the pic) with Overture PETG. As you can see, the nozzle tip gouged the plate and broke off and ended up bending the hot end. What would have caused this to happen? Did I miss a step in the installation of the replacement hot end? Is t

Bambu Labs MMS (Manual Material System) by Imaginarydave - MakerWorld

Bambu Labs Printers, [H]ard

Prusa MK3S+ vs Bambu Lab X1 carbon - Page 10 – General discussion

Bambu Lab X1 Carbon Review: Living In The Future

Bambu Lab X1 Carbon Combo Review - The Tesla of 3D printers

Bambu Lab 3D Unofficial Group

Bambu Lab P1P Review: Bare Bones Speed Freak

Bambu Lab P1P Review: Bare Bones Speed Freak

Bambu Lab X1 Carbon: Info & Discussion (SRO) - Esk8 Electronics

X1-Carbon Enclosure Build - Bambu Lab X1 Series - Bambu Lab

3D Printer Review: Bambu A1 Mini with AMS - Make

Bambu Lab X1 Carbon: Info & Discussion (SRO) - Esk8 Electronics

Medium Accessory Box for Bambu by OlleMark - MakerWorld