Cura 5.3 unnecessary move after toolchange in gcode - UltiMaker

Hi, i build a voron with toolchanger running klipper. I use cura since 2014 but i cant solve that problem. i try to explain it. before toolchange, klipper stores the toolheadposition(blue line) then retract, z hop, toolchange etc. after toolchange the toolhead goes to the old position (green line

5.3.0 strange artifacts in skin (jagged paths on curved surfaces) · Issue #14811 · Ultimaker/Cura · GitHub

Ultimaker cura slices fine but on reading the gcode again through Cura, it shows a faulty 2nd layer [Screenshot attached]. Not sure if it is causing any real issue, but cannot find

UltiMaker Cura 5.3 stable released - Page 2 - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Cura 5.3 unnecessary move after toolchange in gcode - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

How do I turn off this initial triangle? - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Cura Settings Decoded – An Ultimaker Cura Tutorial

Cura 5.3 unnecessary move after toolchange in gcode - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Little help on this Cura slicing or model error? - 3D Printing Stack Exchange

Cura 4.4.1 Prime Tower - skipping layers for secondary extruder · Issue #6909 · Ultimaker/Cura · GitHub

Automated Filament Inking for Multi-color FFF 3D Printing

Cura 5.3.1 Slicing Failure on Scaled Up Chest · Issue #15391 · Ultimaker/ Cura · GitHub

UltiMaker Cura 5.3 stable released - Page 2 - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Cura 3.6 - Tool Change including move to (0,0) · Issue #5383 · Ultimaker/ Cura · GitHub